Why I am unable to lift completely the desired image from KONAD image plate on the plastic stamp?
There are few reasons as follow: Do not :
Do the stamping process under the influence of air blowing, (ie. fan, air-conditioner or wind) as KONAD special nail polish is quick-drying.
To wipe NEW STAMPER glossy surface with cloth or nail polish remover for easy lifting of image.
Apply in too thin layer of KONAD special nail polish on the image plate, resulted the special nail polish dries on the image plate and only part of the image is lifted with KONAD plastic stamp.
When taking the brush from KONAD special nail polish bottle, clear only the excessive polish on one side of the brush by sliding it at the bottle tip and use the other side of the brush to apply special nail polish to desired image within a plate.
Scrape-off excessive KONAD special nail polish slowly from image plate, caused the special nail polish dries on the image plate and only part of the image is lifted with plastic stamp.
Scrape excessive polish from plate quickly at 45 degree towards right side scraper position.
Slow in lifting the image from the image plate.
Press down gently with plastic stamp on image plate and lift up immediately. Complete each step as fast as possible.
Scraper and image plate not cleaned after each use, resulted unclear image being lifted.
Remember to clean the scraper and image plate with nail polish remover after each use.